User manual

Program description
Whoever has worked his way through this manual up
to this point will have probably tried out some form of
programming. Nonetheless, an attempt will be made to
describe each menu in detail.
As already mentioned in section "Operating the dis-
plays" on page 21, you can touch one of the three
gear icons at the bottom right of the basic display identi-
fi ed with "B", "F" and "S" …
000 000
000
000
mz
000%
000%
000
000
BATT TIME 00: 01: 23
MODEL NAME 1
M 1
0:01:23
NORMAL
000:00.0
000:00.0
4.2V
… to open the respective selection menu. These three
menus contain all of the setting and display menus
required to program a model as well as the transmitter,
including telemetry functions.
Note:
The description of the individual menu items
starting on the next double page is offered in
the sequence provided by the transmitter.
Specifi cally, these are:
"B" (green base menu)
Touch the gear icon labelled "B" with a fi nger or the
provided stylus.
BACK
SYSTEM
BASE
FUNCTION
Model Sel
E.P.A
Model Type
Rev/Slow
Sub-Trim
Motor
Timer
TX ctl
Fail Safe
Trim Step
Servo
Out.Swap
CH Set
This menu contains all of the setting and display menus
that are needed to set up the model:
Name Menu Page
Model Sel
"Model Select" 44
Model Type
"Model type" 64
E.P.A
"End Point Adjustment" 66
Rev/Slow
"Servo reversal/control
delay"
68
Sub-Trim
"Servo neutral position" 70
Motor /
THR.CUT
"Throttle Cut"*
72
TX ctl
"Transmitter control" 74
Timer
"Timer" 80
Fail Safe
"Fail-safe" 84
Trim Step
"Trim step" 86
Servo
"Servo monitor / test" 90
CH Set
"Control setting" 92
Out.Swap
"Transmitter output swap" 96
"F" (blue function menu)
Touch the gear icon labelled "F" with a fi nger or the
provided stylus.
Depending on the model type of the currently
active model memory, two different menu
structures are displayed. These can also vary
depending on the basic settings of the model.
The following two menus therefore only offer a selection
as an example:
Common function menus
Name Menu Page
Prog.MIX
"programmable mixer" 100
Trainer
"Trainer" 107
Telemetry
"Telemetry setting" 114
Fixed-wing models
BACK
SYSTEM
BASE
FUNCTION
Q.Link
Wing MIX
D/R,EXP
THR.CRV
Flap MIX
Aile diff
Flap sett
Prog.MIX
V-Tail
Trainer
Telemetry
Butterfly
Name Menu Page
Q.Link
"Q.Link setting" 132
D/R,EXP
"Dual rate, Expo" 136
Wing MIX
"Wing mixer" 140
THR.CRV
"THR.CRV"* 144
* hidden for models without a motor
42
Program description
S1006_mz-24.3.en.indd 42 17.12.2014 15:21:25