User manual

Helicopter models
Advice to pilots switching from some older
Graupner systems:
In comparison to the receiver configuration of
some older transmitters, servo connector 1
(pitch servo) and servo connector 6 (throttle
servo) have been switched. The servos must be
connected to the receiver outputs as depicted on the
right. Outputs that are not required are simply not
assigned.
More details on the swashplate type may be found on
page 48 in the menu "Model selection".
Installation instructions
The servos must be connected to the
receiver in the indicated sequence. Outputs
that are not required are simply not assigned.
Follow the instructions on the subsequent pages.
Note:
In order to take advantage of the comfort and
safety features of the throttle limiter, starting
on page 94, a governor should be
connected to receiver output 6 instead of receiver
output 8 in the adjacent receiver configuration. More
information on this subject can be found on page 182.
Receiver assignment for helicopter models …
… with 1 to 3 swashplate servos
Receiver power supply
Free or aux. function
Free or aux. function
Tail rotor servo (gyro system)
Roll 1 servo
Pitch-axis 1 servo
Free or speed governor or aux. function
Receiver power supply
Collective pitch or roll 2 or
Pitch-axis 2 servo
Free or aux. function
Throttle servo or speed controller
Gyro gain
Free or aux. function
Free or aux. function
… with 4 swashplate servos
Receiver power supply
Free or aux. function
Free or aux. function
Tail rotor servo (gyro system)
Roll 1 servo
Pitch-axis 1 servo
Free or speed governor or aux. function
Receiver power supply
Roll 2 servo
Pitch-axis 2 servo
Throttle servo or speed controller
Gyro gain
Free or aux. function
Free or aux. function
All of the relevant menus for helicopter models are
identified with a helicopter icon in the "Program
description section …
… so that you only have to deal with these menus when
programming helicopter models.
41
Receiver configuration - Helicopter models
S1006_mz-24.3.en.indd 41 17.12.2014 15:21:24