User manual

Installation instructions
The servos must be connected to the
receiver in the indicated sequence. Outputs
that are not required are simply not assigned.
Please note following for the mz-18 HoTT transmit-
ter:
By default, the 9-channel mz-18 HoTT
transmitter can only control outputs 1 to 9. Any
servos that are connected to outputs 10 to 12
remain in their neutral position with this transmitter.
Follow the instructions on the subsequent pages.
Fixed-wing models with and without a motor with up
to 4 ailerons and up to 4 flaps …
… and a normal tail unit or 2 elevator servos
Receiver power supply
Free or left aileron 2 or aux. function
Free or right aileron 2 or aux. function
Rudder
Aileron or left aileron
Elevator or 1st elevator
Free or 2nd elevator or aux. function
Receiver power supply
Airbrake or throttle servo
or speed controller (electric motor)
Right aileron or aux. function
Flap or left flap
Right flap or free or aux. function
Free or left flap 2 or aux. function
Free or right flap 2 or aux. function
… and a V-tail
Receiver power supply
Free or aux. function
Free or aux. function
Aileron or left aileron
Free or aux. function
Receiver power supply
Airbrake or throttle servo
or speed controller (electric motor)
Right aileron or aux. function
Flap or left flap
Right flap or free or aux. function
Free or left flap 2 or aux. function
Free or right flap 2 or aux. function
Left rudder / elevator
Right rudder / elevator
Delta/flying wing models with and without a motor
with up to 4 ailerons/elevators and 4 flap/elevator
servos
Receiver power supply
Free or aux. function
Free or aux. function
Right elevon
Right elevon
Free or aux. function
Receiver power supply
Airbrake or throttle servo
or speed controller (electric motor)
Free or aux. function
Free or left flap / elevator
Free or right flap / elevator
Free or aux. function or left flap 2 / elevator
Free or aux. function or right flap 2 / elevator
Free or rudder
Due to the different installation of the servos and rudder
linkages, the operating direction for certain servos may
be reversed. The following table offers assistance in this
regard.
Model
type
Servo with wrong
direction of
rotation
Solution
V-tail Reversed rudder
and elevator
Change the poles
of servos 3 + 4
in the submenu
"REVERSE"
The rudder is
correct and the
elevator is reversed
Switch servos 3 + 4
on the receiver
The elevator is
correct
The rudder is
reversed
Change the poles
of servos 3 + 4
in the submenu
"REVERSE", and on
the receiver
Delta,
Flying
wing
The elevator
and aileron are
reversed
Change the poles
of servos 2 + 3
in the submenu
"REVERSE"
The elevator is
correct and the
aileron is reversed
Change the poles
of servos 2 + 3
in the submenu
"REVERSE", and on
the receiver
The aileron is
correct and the
elevator is reversed
Switch servos 2 + 3
on the receiver
All of the relevant menus for a fixed-wing model are
identified by an wing icon in the "Program descriptions"
…
… so that you only have to deal with these menus when
programming fixed-wing models.
Receiver assignment
Fixed-wing models
40
Receiver configuration - Airplane models
S1006_mz-24.3.en.indd 40 17.12.2014 15:21:24