User manual

You can then start a binding procedure for the transmit-
ter and receiver.
If a linked receiver is reset and the associated model
memory is active in the switched-on transmitter, the
LED shines green continuously for about 2-3 seconds
to indicate that your transmitter/receiver system is ready
to use.
Please note the following:
Resetting resets all of the settings in the
receiver to the factory settings with the
exception of the binding information.
If a reset is performed accidentally, all of these
settings that were made using the "Telemetry" menu
in the receiver should be restored.
Resetting is particularly recommendable when you
want to switch a receiver to a different model. This
makes it easy to keep settings which do not match
from being transferred.
Receiver firmware updates can be obtained via the
receiver telemetry connection using a computer
operating on Windows XP, Vista, 7 or 8. To do this, you
will need a USB interface (order No. 7168.6) and the
adapter cable (order No. 7168.S) that come with the
set. The programs and files which are also required for
updating the transmitter as well as detailed instructions
for the corresponding product (combined into one
software package) can be downloaded from www.
graupner.de.
Download this software package from the Internet, and
unpack it on your computer. All other information can
be found in the instructions that come in the software
package.
Note:
After your receiver has been registered at
https://www.graupner.de/en/service/product_
registration.aspx, you will automatically be
notified of updates by e-mail.
Receiver firmware updates
Backing up the receiver settings
The software package downloaded from the Internet
and opened on your computer contains the program
"Firmware_Upgrade_grStudio". This program may
already be installed on your computer.
Using the "Receiver settings" section of the Firmware_
Upgrade_grStudio program, you can save all of the
settings programmed in a receiver within a file on the
computer so that you can upload them to the receiver
if needed. This makes it unnecessary to have to
reprogram the receiver using the "Telemetry" menu.
The USB interface (order No. 7168.6) and the interface
cable (order No. 7168.S) that come standard with the
mz-18 HoTT (order No. S1005) and mz-24 HoTT
(order No. S1006) remote control sets are required for
this program.
All other information can be found in the instructions that
come in the software package.
33
Starting the receiver
S1006_mz-24.3.en.indd 33 17.12.2014 15:21:22