User manual

Proportional slider SL1
Data socket, for example
to connect a smart box
Connector socket for
headphones
Card slot for micro SD cards
5-pin mini-USB connector
DSC socket Charging socket
Carrying handle with attached
stylus for alternatively operating
the touch-sensitive display
Backside of the transmitter
(The fi gure shows the mz-24 HoTT transmitter.)
Proportional slider SL2
Rotatable and foldable antenna
24
Description of the transmitter - Back side and connections on the back
DSC socket
The abbreviation "DSC" is from the initial letters of the
original function, "direct servo control". With the HoTT
system, "direct servo control" using a diagnostic cable is
not possible for technical reasons.
The standard two-pin DSC socket on the back of the
mz-18 HoTT and mz-24 HoTT transmitters functions
as a trainer or pupil socket as well as an interface for
fl ight simulators or other external devices.
To ensure a correct DSC connection, observe the
following:
1. Perform any necessary adaptations in the menu.
To adapt to the transmitter to a trainer system, see
page 107.
2. Connect the other end of the connecting cable to the
desired device while observing the relevant operating
instructions.
Important:
Make sure that all the plugs are
securely inserted in the respective
sockets, and only use the provided
plug-in connectors with a 2-pin jack plug on the
DSC side.
3. In the "Transmitter control" submenu, page 74,
you can set one of the following modes in the "DSC
output" line depending on the number of functions to
be transmitted: PPM10, PPM16, PPM18 and PPM24.
Default: PPM10.
Instructions regarding fl ight simulators:
•
Given the numerous fl ight simulators on
the market, it is possible that the contacts
on the jack plug or DSC module may have
to be adapted by Graupner Service.
NOTE:
•
When your transmitter is directly connected
to a desktop computer or laptop by a
connecting cable (DSC cable) and/or a
computer interface is connected to your simulator,
the transmitter may be destroyed by electrostatic
discharge. This type of connection should therefore
S1006_mz-24.3.en.indd 24 17.12.2014 15:21:19