User manual

QUA Signal quality expressed as percentage
1-BAT-2 BATT 1 and BATT 2
1-TEMP-2 Temperature of sensors 1 and 2
BAT-1/
BAT-2
Cell voltage of each cell 1 … 7 of battery
1 and each cell 1 … 7 of battery 2
VARIO
BACK
NEXT
m/s
270.0
QUA 100
-270.0
-000.5
-0001m
m/3s
270.0
-270.0
+000.1
m/10s
270.0
-270.0
000.0
-0002m
MIN
MAX
0000m
This display visualizes the data of a Vario module
connected to the receiver (order No. 33601).
The abbreviations have the following meanings:
Value Explanation
QUA Transmitter signal quality received by the
receiver expressed as percentage, see
page 116.
MAX Maximum altitude relative to the starting
location in meters
MIN Maximum depth below the starting
location in meters
m/s Ascent/descent in m/1 s
m/3s Ascent/descent in m/3 s
m/10s Ascent/descent in m/10 s
GPS
BACK
NEXT
N 000°00 0000
m/s
QUA 100
000.0
200
4000
0000m
DIST
SPEED
000
000km/h
300100
m/3s
E 000°00 0000
0000m
ALT
000
This display shows the data of a GPS module with an
integrated Vario module connected to the receiver (order
No. 33600).
In addition to the current position data and model
speed in the center of the display, the current height is
displayed in relation to the starting location along with
the ascent and descent of the module in m/1 s and
m/3 s; the current reception as well as the distance from
the starting location are also shown.
The abbreviations have the following meanings:
Value Explanation
QUA Transmitter signal quality received by the
receiver expressed as percentage, see
page 116.
DISTANCE Distance
N / E North/east
m/s Ascent/descent in m/1 s
m/3s Ascent/descent in m/3 s
Kmh
Speed above ground calculated by the
GPS system
ALT Current altituderelative to the starting
location
ESC (Electronic Speed Controller)
BACK
NEXT
cur-VOLT-min
cur-TEMP-max
30.0 70
QUA 100
-200 -20
30000
cur-RPM-max
cur-AMP-max
00000mAh
CAPACITY
0
0
0 0
00.0V 00.0V
-020°C -020°C
60000
000000rpm 000000rpm 000.0A
000.0A
This display shows the data from a brushless controller
connected to the receiver with integrated telemetry
(order No. 33718 to 33770 and 33850 current at the
time of revision of this manual).
The display shows the current and maximum electrical
values of the drive, the current and maximum
temperature of the controller, and the current and
maximum speed of the motor connected to the
controller.
The abbreviations have the following meaning:
Value Explanation
QUA Transmitter signal quality received by the
receiver expressed as percentage, see
page 116.
cur-VOLT-
min
Left value: current battery charge
Right value: lowest battery level since the
device has been switched on
cur-TEMP-
max
Left value: current controller temperature
Right value: maximum controller
temperature since the device has been
switched on
cur-RPM-
max
Left value: current motor speed
Right value: maximum motor speed since
the device has been switched on
216
Telemetry data display
S1006_mz-24.3.en.indd 216 17.12.2014 15:22:57