User manual

If acoustic warnings sound and the normal transmitter
display is covered by this display, take note of the
message in red. For example because the transmitter's
supply voltage has reached the warning threshold set in
the submenu "Etc.Set" of the system menu, page 202:
BACK
CLR
ON
TX VOLT
03
3.5V
AUTO LOAD
RX VOLT
00
3.7V
STRENGTH
00
000%
ESC CUR.
00
000.0A
ESC VOLT
00
00.0V
STRENGTH ALARM
ON
At the same time, the display contrast is reduced to 05
to save power.
This warning can be kept from reappearing by touching
the ON button at the top right then deleted by touching
the BACK button at the top left in the display. (In specific
cases, stop operating the model as soon as possible
and charge the transmitter).
The red number at the top right shows the number of
current warnings; in the above example, the warning is
the third one. This count can be deleted by touching the
CLR button at top left.
All other warnings in this display can be handled in
the same way. However, in the case of a field strength
alarm, you can also suppress other alarms triggered by
the low field strength by touching the ON button under
"STRENGTH ALARM" for the duration of the current
operation of the transmitter.
23
Description of the transmitter - Warning
S1006_mz-24.3.en.indd 23 17.12.2014 15:21:17