User manual

In the basic transmitter display, use your fi nger or the
provided stylus to touch the gear icon labelled "S":
000 000
000
000
mz
000%
000%
000
000
BATT TIME 00: 01: 23
Graubele
M 1
0:01:23
NORMAL
000:00.0
000:00.0
4.1V
RX TX
RX 00.0V
Touch
The display switches to the purple main menu. Use a
fi nger or the provided stylus to touch the menu item
"Etc.Set":
BACK
SYSTEM
BASE
FUNCTION
ST mode
Etc. Set
Warning
Display
MP3
Stick Cali
Touch
In the submenu "Etc.Set", you can switch on and off the
defaults for the lines "Battery type" and "Batt warning",
as well as the volume of the acoustic output and the
power-on melody of the transmitter.
NOTE:
The mz-18 HoTT transmitter comes stand-
ard with a 4-cell NiMH battery, and the
mz-24 HoTT transmitter comes standard
with a 1s2p lithium-ion battery. The defaults for the
two transmitters are correspondingly different in the
lines "Battery type" and "Batt warning" described
below.
Etc.Set
Various transmitter-wide settings
Note:
Firmware version V 1.023 expands the
available setting options by adding the line
"Vario Volume".
Battery type
In the fi rst line, inform the transmitter whether the power
supply is a four-cell NiMH battery or a 1s lithium battery.
Depending on the setting, an adapted voltage range is
offered in the next line, BATT warning.
To make any necessary changes to the setting, touch
the fi eld of the line "Battery type" with a fi nger or the
provided stylus:
BACK
Graubele
Battery type
Batt warning
Power on Melody
Speaker Volume
NiMH
4.8V
ON
03
INC
RES
DEC
Vario Volume
03
Touch
The color of the fi eld switches from red to blue:
BACK
Graubele
Battery type
Batt warning
Power on Melody
Speaker Volume
NiMH
4.8V
ON
03
INC
RES
DEC
Vario Volume
03
Touch INC or DEC at the right edge of the display to
select the appropriate battery type, for example:
BACK
Graubele
Battery type
Batt warning
Power on Melody
Speaker Volume
Lith.
3.6V
ON
03
INC
RES
DEC
Vario Volume
03
Touch the RES button to reset a changed value back
to the default.
BATT warning
In the "BATT warning" line, you can set the warning
threshold of the display …
BACK
CLR
ON
TX VOLT
01
3.6V
AUTO LOAD
RX VOLT
00
3.7V
STRENGTH
00
000%
ESC CUR.
00
000.0A
ESC VOLT
00
00.0V
STRENGTH ALARM
ON
… depending on the selected battery type in the line
above, in increments of 0.1 V between 4.5 and 5.5 V
(NiMH battery) or 3.4 and 4.2 V (lithium-ion/lithium
polymer battery). Make sure that the set value is not too
low to give you suffi cient time to land your model after a
battery warning.
To make any necessary changes to the setting, touch
the fi eld of the line "BATT warning" with a fi nger or the
provided stylus:
202
System menu - ETC set
S1006_mz-24.3.en.indd 202 17.12.2014 15:22:50