User manual

BACK
NORMAL
Starlet
S
(RATE)
AILE >> THRO
000%
INC
RES
DEC
A
000%
B
Then change the current value in the blue (active)
value fi eld by touching the INC or DEC buttons at
the right edge of the display, for example:
NORMAL
Starlet
–012%
RES
A
000%
B
BACK
S
(RATE)
AILE >> THRO
INC
DEC
If desired, use the same procedure for the value on
the opposite side of the control travel, for example:
NORMAL
Starlet
–012%
RES
A
–021%
B
BACK
S
(RATE)
AILE >> THRO
INC
DEC
Touch the RES button to reset a changed value in a
blue (active) value fi eld to the default value.
After making your settings, leave this display and
go to the "Throttle mixer" selection by touching
the BACK button at the top left of the display.
NORMAL
Starlet
–012%
RES
A
–021%
B
BACK
S
(RATE)
AILE >> THRO
INC
DEC
Touch
Important note:
The mixer values portrayed here are for
demonstration purposes only and do not
represent real values.
BACK
NORMAL
Starlet
S
ACT
ELEV >> THRO
RUDD >> THRO
AILE >> THRO
INH
INH
ON
>>
>>
>>
ON
ON
ON
SET CTL
MIX.TYPE
Select another mixer here if desired and adjust it as
described.
• "CTL" column (control/switch)
In this column as described in the section "Control,
switch and control switch assignment" on page 38,
assign a control to the respective mixer that you can
use to switch on and off the mixer, for example:
BACK
NORMAL
Starlet
S
ACT
ELEV >> THRO
RUDD >> THRO
AILE >> THRO
INH
INH
ON
>>
>>
>>
ON
ON
SW7
SET CTL
MIX.TYPE
After making your settings, leave this menu and go to
"Menu selection" by touching the BACK button at the
top left of the display.
BACK
SYSTEM
BASE
FUNCTION
Q.Link
PIT.CRV
D/R,EXP
THR.CRV
Gyr/Gover
THR.HOLD
S.Limit
Swash
S.MIX
THR.MIX
Prog.MIX
PIT>>RUDD
Trainer
Telemetry
197
Helicopter model function menu - Throttle mixer
S1006_mz-24.3.en.indd 197 17.12.2014 15:22:47