User manual

The display is basically operated by touching the
desired fi eld with a fi nger or the provided stylus:
000 000
000
000
mz
000%
000%
000
000
BATT TIME 00: 01: 23
MODEL NAME 1
M 1
0:01:23
NORMAL
000:00.0
000:00.0
4.2V
By touching the model memory fi eld labelled "M 1" in
the above display with a fi nger or the provided stylus,
the "Model memory" selection menu opens.
BACK
NEXT
01
MODEL NAME 1
02
03
04
05
06
SEL
NEW
IMP.M
EXP.M
RES
CPY
MODEL NAME 1
MODEL NAME 2
MODEL NAME 3
MODEL NAME 4
MODEL NAME 5
MODEL NAME 6
In this menu, you can change the model by touching the
desired model memory.
Just as described on page 45, touch NEW to start
programming a new model, or touch the fi eld MODEL
NAME 1 at the upper edge of the display to switch
to the "Model name" entry menu, or touch BACK at
the top left to return to the previous menu item. In
contrast, touch the button NEXT [next page] (generally
using the rotation method) which is also available in
several menus to go to the next page. In the above
display of the model memory, to the display of model
memories 07 … 12, etc.
The other fi elds on the left side identifi ed with an
asterisk (*) basically function the same way.
In contrast, if you touch one of the three gear icons
Operating the displays
identifi ed with"B", "F", and "S", special selection menus
open on the bottom right from which you can switch to
other submenus. Starting with the green base menu,
see page 44the selection displays appear as follows:
BACK
SYSTEM
BASE
FUNCTION
Model Sel
E.P.A
Model Type
Rev/Slow
Sub-Trim
Motor
Timer
TX ctl
Fail Safe
Trim Step
Servo
Out.Swap
CH Set
It should be noted that they blue FUNCTION menu
which is described starting on page 100 or 171
contains model-type-specifi c submenus. The fi rst of the
two following pictures therefore shows examples of the
menu structure of a fi xed-wing model, and the second
one shows the menu structure of a helicopter model:
BACK
SYSTEM
BASE
FUNCTION
Q.Link
Wing MIX
D/R,EXP
THR.CRV
Flap MIX
Aile diff
Flap sett
Prog.MIX
V-Tail
Trainer
Telemetry
Butterfly
BACK
SYSTEM
BASE
FUNCTION
Q.Link
PIT.CRV
D/R,EXP
THR.CRV
Gyr/Gover
THR.HOLD
S.Limit
Swash
S.MIX
THR.MIX
Prog.MIX
PIT>>RUDD
Trainer
Telemetry
The pink SYSTEM menu that can be opened by
pressing "S" and is explained starting on page 208
appears as follows:
BACK
SYSTEM
BASE
FUNCTION
ST mode
Etc. Set
Warning
Display
MP3
Stick Cali
The telemetry displays which can be opened by
pressing "T" and are described in detail starting on page
213 appear as follows:
BACK
0.0V
VO LT
0.0V
L-VOLT
3.0 3.0
R
40.0
6.0 6.0
0 0
70
-20
00°C
TEMP
00dB
00dB
T
0000ms
L
000%
S
000%
Q
21
Description of the transmitter - Display
S1006_mz-24.3.en.indd 21 17.12.2014 15:21:16