User manual

THR.HOLD
Throttle HOLD position
In the basic transmitter display, use a fi nger or the
provided stylus to touch the gear icon labelled "F":
000 000
000
000
mz
000%
000%
000
000
BATT TIME 00: 01: 23
Starlet
M 2
0:01:23
NORMAL
000:00.0
000:00.0
4.2V
RX TX
RX 00.0V
Touch
The display switches to the blue function menu. Use
a fi nger or the provided stylus to touch the menu item
"THR.HOLD":
BACK
SYSTEM
BASE
FUNCTION
Q.Link
PIT.CRV
D/R,EXP
THR.CRV
Gyr/Gover
THR.HOLD
S.Limit
Swash
S.MIX
THR.MIX
Prog.MIX
PIT>>RUDD
Trainer
Telemetry
Touch
throttle HOLD position
BACK
Starlet
S
ACT
CTL
SET
DEC

RES
INC
–100%
ON
INH

During competition, is expected that gas engines should
be completely switched off. In the training phase, this is
a bit inconvenient since you would have to restart the
motor after each autorotation landing.
Therefore, set the value during the training phase in this
display so that the gas motor can be kept idling during
the autorotation phase without the clutch engaging, and
so any electric drive is defi nitely off.
Note:
With the "Thr.CUT" option in the Base menu, there is an
alternative emergency off function.
• ACT line
To switch on and off this option, touch the value fi eld
of the "ACT" line with a fi nger or the provided stylus,
for example:
Starlet
SET

RES
–100%
ON
ON

BACK
S
ACT
CTL
DEC
INC
• CTL line
as described in the section "Control, switch and
control switch assignment" on page 38, in this line
assign the same switch with which you switch to the
autorotation phase, for example:
Starlet
SET

RES
–100%
SW3
ON

BACK
S
ACT
CTL
DEC
INC
• SET line
The green arrow to the left of the bar graph indicates
the current position of the throttle servo. The red ar-
row to the right indicates the currently set autorota-
tion throttle position.
To change the current autorotation throttle position,
use the throttle/pitch control stick to move the
green arrow, and possibly the throttle trim, to the
position that the throttle servo is to assume during
autorotation, for example:
Starlet
SET

RES
–100%
SW3

ON
BACK
S
ACT
CTL
DEC
INC
Then touch the value fi eld of the "SET" line with a
fi nger or the provided stylus:
Starlet
SET

RES
–100%
SW3

ON
BACK
S
ACT
CTL
DEC
INC
Touch
The color of the fi eld switches from red to blue:
190
Helicopter model function menu - THR HOLD
S1006_mz-24.3.en.indd 190 17.12.2014 15:22:43