User manual

NORMAL
Starlet
ENT
TRIM
–036%
000%
000%
2
BACK
IN
OUT
POINT
OFF
INC
DEC
Y-axis
X-axis
ST ON
CURVE
S
Pitch min.
FORWARD
Touch the X-axis button again to deactivate the
function.
Notes:
• If you move the red point horizontally
away from the current control position,
the point becomes green after a short
while, and a "?" appears in the Point line. This
question mark does not relate to the point which
has been moved but rather indicates that another
point can be set at the current control position.
• Note that the percentage in the "IN(put)" online
and "OUT(put)" lines always refers to the
momentary control stick position, and not to the
position of the point.
• Y-axis button (Y-axis)
Activate this function by touching the button at
the bottom edge of the display with a finger or the
provided stylus.
You can then move an active (red) point to the
top with the INC button, and to the bottom with
the DEC button, for example:
NORMAL
Starlet
ENT
TRIM
–036%
+027%
+027%
2
BACK
IN
OUT
POINT
OFF
INC
DEC
Y-axis
X-axis
ST ON
CURVE
S
Pitch min.
FORWARD
Touch the Y-axis button again to deactivate the
function.
Note:
Remember that the percentages in the "IN"
and "OUT" line always refer to the
momentary position of the control stick and
not to the position of the point.
Rounding off the channel 1 curve
• ON/OFF button in the "Curve" line
The standard angular curve can be automatically
rounded by turning on the rounding function by
pressing a button with a finger or the provided stylus,
for example:
NORMAL
Starlet
ENT
TRIM
–036%
+027%
+027%
2
BACK
IN
OUT
POINT
OFF
INC
DEC
Y-axis
X-axis
ST ON
CURVE
S
Pitch min.
FORWARD
Touch
NORMAL
Starlet
ENT
TRIM
–036%
+027%
+027%
2
BACK
IN
OUT
POINT
ON
INC
DEC
Y-axis
X-axis
ST ON
CURVE
S
Pitch min.
FORWARD
Important note:
The curves portrayed here are for
demonstration purposes only and do not
represent real pitch curves.
Additional functions
• TRIM button
The mz-18 HoTT and mz-24 HoTT transmitters
have a function that is integrated in the transmitter
program for trim up to six support points of the two
options "throttle curve" and "pitch curve" during flight.
Touch the TRIM button at the top right edge of the
display with a finger or the provided stylus to open
the corresponding display:
NORMAL
Starlet
ENT
TRIM
–036%
+027%
+027%
2
BACK
IN
OUT
POINT
ON
INC
DEC
Y-axis
X-axis
ST ON
CURVE
S
Pitch min.
FORWARD
Touch
177
Helicopter model function menu - PIT.CRV
S1006_mz-24.3.en.indd 177 17.12.2014 15:22:37