User manual

Buttons   as well as ESC and
ENT
Although the two mz-18 HoTT and mz-24 HoTT
transmitters are primarily operated by touching the
touch-sensitive screen with a fi nger or the provided
stylus, the transmitters can be operated in special cases
using the two sets of three buttons on the side of the
display.
Buttons to the left of the display
• Adjusting buttons 
1. Set the parameters in the setting fi elds after they
are activated by pressing the ENT button.
2. Simultaneously press the  buttons to reset a
changed parameter in the active entry fi eld to the
default ( CLEAR).
3. Simultaneously pressing the buttons in the basic
display as well as in all menus with SERVO or
a Sv button switches directly to the »Servo dis-
play«.
• ESC button
Firmware version before V 1.023
Press the ESC button to confi rm the current
setting and deactivate the active settings fi eld.
Firmware version V 1.023 and higher
Pressing the ESC button brings about a stepwise re-
turn to function selection or back to the basic display.
Any setting changed in the meantime is retained.
Buttons to the right of the display
• Selection buttons 
"Scrolling" through the menu lines in the setting men-
us or through the icons that can be called up in the
basic display.
• ENT button
Activate (confi rm) the settings fi elds by pressing the
ENT button.
Access to adjustments can be blocked in the basic
transmitter display by simultaneously pressing the ESC
and ENT buttons for about one second. This is indicated
by a change of colour of the button icon at the top right
in the display from gray to blue/yellow:
The lock is activated immediately, but the controls
remain operational.
Press the ESC and ENT buttons again for about three
seconds to release the lock. The colour of the icon
returns to grey:
Button lock Digital trim
With an optical and acoustic display
The two control sticks come with digital trim. Briefl y
touch the trim switch to move the neutral position of the
control stick by a specifi c value with each click. Hold
down the switch to move the trim in the corresponding
direction with increasing speed.
The adjustment is made audible by tones of varying
levels. It is therefore easy to fi nd the middle position
during fl ight without looking at the display. If you go past
the middle position, a brief pause is inserted.
The current trim values are automatically saved when
the model memory is changed. In addition, the digital
trim functions within a memory in specifi c relation to the
Quick Link (with the exception of the trim of the Throttle/
brake valves or the gas/pitch control stick called control
function "THR" (channel 1)).
When a gas motor is selected in the "Drive type" display,
page 47, the trim of the throttle control stick only func-
tions for wing or helicopter models in the bottom half of
the control stick path, that is, only in the starting range.
The current trim positions are displayed numerically and
graphically in the transmitter's basic display (see the
picture on the left and on the next page) as well as in a
special display, see page 88.
19
Description of the transmitter - Buttons, button lock and digital trimming
S1006_mz-24.3.en.indd 19 17.12.2014 15:21:09