Manualshelf

User manual

ManualsBrandsGRAUPNER ManualsModel Making Remote ControlsMZ-18 HoTT Handheld RC 2,4 GHz No. of channels: 9 Incl. receiver
141142143144145146147148149150
Deleting a support point
In order to delete the set support points 1 to 5, move
the vertical green line with the control stick next to
the relevant support point. Once the support point
number appears along with the associated value
in the line "POINT" and the point is red (see the
screenshot below), you can delete it by touching
the ENT button, for example:
NORMAL
ENT
000%
000%
+050%
2
Graubele
BACK
IN
OUT
POINT
OFF
INC
DEC
Y-axis
X-axis
ST ON
CURVE
S
Touch
NORMAL
ENT
000%
000%
000%
?
Graubele
BACK
IN
OUT
POINT
OFF
INC
DEC
Y-axis
X-axis
ST ON
CURVE
S
Changing the support point value
• X-axis button (X-axis)
Activate this function by touching the button at
the bottom edge of the display with a finger or the
provided stylus.
You can then move an active (red) point to the
right by pressing the INC button, or to the left by
pressing the DEC button, for example:
NORMAL
ENT
000%
+018%
000%
?
Graubele
BACK
IN
OUT
POINT
OFF
INC
DEC
Y-axis
X-axis
ST ON
CURVE
S
Touch the X-axis button again to deactivate the
function.
Note:
• If you move the red point horizontally
away from the current control position,
the point soon becomes green and a
"?" appears in the POINT line. This question mark
does not relate to the point which has been
moved but rather indicates that another point can
be set at the current control position.
• Remember that the percentages in the "IN" and
"OUT" line always refer to the momentary position
of the control stick and not to the position of the
point.
• Y-axis button (Y-axis)
Activate this function by touching the button at
the bottom edge of the display with a finger or the
provided stylus.
You can then move an active (red) point upward by
pressing the INC button, or downward by pressing
the DEC button, for example:
NORMAL
ENT
–030%
+035%
+067%
2
Graubele
BACK
IN
OUT
POINT
OFF
INC
DEC
Y-axis
X-axis
ST ON
CURVE
S
Touch the Y-axis button again to deactivate the
function.
Note:
Remember that the percentages in the "IN"
and "OUT" line always refer to the
momentary position of the control stick and
not to the position of the point.
Rounding off the channel 1 curve
• ON/OFF button in the "Curve" line
The default angled curve profile can be automatically
rounded off by turning on the rounding function by
pressing this button with a finger or the provided
stylus, for example:
NORMAL
ENT
–030%
+035%
+067%
2
Graubele
BACK
IN
OUT
POINT
OFF
INC
DEC
Y-axis
X-axis
ST ON
CURVE
S
Touch
146
Airplane model function menu - THR.CRV
S1006_mz-24.3.en.indd 146 17.12.2014 15:22:17