User manual

BACK
NORMAL
Graubele
S
AILE >> RUDD
A
(RATE) B
+050%
+050%
INC
RES
DEC
Touch the RES button to reset a changed value in the
blue (and hence active) field to the default.
Note:
To graphically display the current servo
positions, you can access them from nearly
every menu with the button labelled SERVO
or S in the top right of the display with a finger or the
provided stylus. Touch the BACK button to return to
your starting point.
Touch the BACK button at the top left of the display …
BACK
NORMAL
Graubele
S
AILE >> RUDD
A
(RATE) B
+050%
+050%
INC
RES
DEC
Touch
… to return to the mixer selection.
MIX.TYPE
RUDD >> AILE
AILE >> RUDD
RUDD >> ELEV
ON
ON
INH
>>
>>
SW6
SW8
ON
>>
ACT CTLSET
BACK
NORMAL
Graubele
S
RUDD >> ELEV line (rudder >> elevator)
Frequently, the behaviour of the transverse axis is influ-
enced when the rudder is actuated. This is particularly
problematic in "knife edge flying" in which the only lift
is from the fuselage when the rudder is deflected since
the wings are vertical in this flight position. Changes
in direction can occur as if the elevator were actuated.
A correction is necessary along the transverse axis
(elevator) within an adjustable range when the rudders
are controlled.
Of course, the rudder and elevator remain separately
controllable.
The setting range of ±150 % makes it possible to
appropriately adapt the direction of deflection. This
mixer can optionally be switched on and off by one of
the controls which cannot be independently reset, or
a control switch if applicable, so that the model can be
controlled exclusively using the rudder or elevator.
To set the mixer, use a finger or the provided stylus to
touch the middle button in the line "RUDD >> ELEV":
MIX.TYPE
RUDD >> AILE
AILE >> RUDD
RUDD >> ELEV
ON
ON
INH
>>
>>
SW6
SW8
ON
>>
ACT CTLSET
BACK
NORMAL
Graubele
S
Touch
The corresponding setting menu opens:
BACK
NORMAL
Graubele
S
RUDD >> ELEV
A
(RATE) B
+100%
+100%
INC
RES
DEC
To enable this, touch the desired value field, such as
the left one, with a finger or the provided stylus:
BACK
NORMAL
Graubele
S
RUDD >> ELEV
A
(RATE) B
+100%
+100%
INC
RES
DEC
Touch
The color of the field switches from red to blue:
BACK
NORMAL
Graubele
S
RUDD >> ELEV
A
(RATE) B
+100%
+100%
INC
RES
DEC
Set the desired value with the INC or DEC button at
the right edge.
Use the same procedure for a value on the plus side of
the control travel, for example:
142
Airplane model function menu - Wing Mix
S1006_mz-24.3.en.indd 142 17.12.2014 15:22:15