User manual

SENSOR
Display of active/inactive sensors
BACK
Graubele
RX SELECT
SETTING & DATA VIEW
SENSOR
RF STATUS VIEW
VOICE TRIGGER
RX1
>>
>>
>>
>>
Touch
With transmitters of the type mz-18 HoTT and
mz-24 HoTT, any sensors that are connected
to the receiver are automatically recognized
and activated when the power supply is switched on.
Active or inactive sensors are automatically labelled
in this submenu provided that a telemetry link exists.
Manual sensor selection is then unnecessary and
impossible, for example:
BACK
Graubele
GENE
ELEC
VARIO
GPS
ESC
ON
OFF
OFF
ON
OFF
ONRECV
Touch the corresponding button with a finger or the
provided stylus …
BACK
Graubele
RX SELECT
SETTING & DATA VIEW
SENSOR
RF STATUS VIEW
VOICE TRIGGER
RX1
>>
>>
>>
>>
Touch
… to open the selected submenu. This visualises the
quality of the connection between transmitter and
receiver:
BACK
Graubele
100%
–60dB
0010ms
–5dB
5.3
090%
QU
TD
ERR
RD
Vc
STR
3.6
Vm
1 2 3 4
5 6
7
8 9 10
11
12
13 14
15
1 2 3 4
5 6
7
8 9 10
11
12
13 14
15
Top row: Level of channels 1 … 75 coming
from the receiver of the 2.4 GHz
band in dBm at the transmitter.
Bottom row: Level of channels 1 … 75 coming
from the transmitter of the 2.4 GHz
band in dBm at the receiver.
Note:
The height of the bar is a measure of the reception
level expressed as logarithmic values with the unit dBm
(1 mW = 0 dBm).
0 dBm corresponds to the two baselines in the above
graph. Consequently, the level is poorer the higher the
bar and vice versa (see also "S-dBm (reception level)"
on page 116).
Display of RF status
In addition to the graphic display of the reception level,
additional numeric information is provided to the left.
The abbreviations have the following meaning:
Value Explanation
QUA Quality expressed as a percentage of the
signal packages from the receiver arriving at
the transmitter
STR Quality expressed as a percentage of the
signal packages from the transmitter arriving
at the receiver
TD Level in dBm of the signal from the receiver
arriving at the transmitter
ERR Shows the longest time in increments of
10 ms in which data packages were lost when
transmitting from the transmitter to receiver
RD Level in dBm of the signal from the transmitter
arriving at the receiver
Vc Current operating voltage of the receiver
Vm "L.R-VOLT" shows the lowest operating
voltage of the receiver since the last time the
receiver was switched on.
128
Function menu - Telemetry | Sensor / Display of RF status
S1006_mz-24.3.en.indd 128 17.12.2014 15:22:07