Manualshelf

User manual

ManualsBrandsGRAUPNER ManualsModel Making Remote ControlsMZ-18 HoTT Handheld RC 2,4 GHz No. of channels: 9 Incl. receiver
101102103104105106107108109110
NORMAL
Graubele
ENT
–085%
000%
000%
1
>>
BACK
S
IN
OUT
POINT
ON
INC
DEC
Y-axis
X-axis
ST ON
ACT
CH8
CH10
ONCTL
Touch
NORMAL
Graubele
ENT
–085%
000%
000%
1
>>
BACK
S
IN
OUT
POINT
ON
INC
DEC
Y-axis
X-axis
ST ON
ACT
CH8
CH10
ONCTL
Changing the support point value
• X-axis button (X-axis)
Activate this function by touching the button at
the bottom edge of the display with a fi nger or the
provided stylus.
You can then move an active (red) point to the
right by pressing the INC button, or to the left by
pressing the DEC button: For example, to move
point 1 set at -45% and point 2 set at +45% precisely
between the end position and middle position:
NORMAL
Graubele
ENT
+050%
000%
000%
2
>>
BACK
S
IN
OUT
POINT
ON
INC
DEC
Y-axis
X-axis
ST ON
ACT
CH8
CH10
ONCTL
Touch the X-axis button to deactivate the function.
Note:
•
If you move the red point horizontally
away from the current control position,
the point soon becomes green and a
"?" appears in the POINT line. This question mark
does not relate to the point which has been
moved but rather indicates that another point can
be set at the current control position.
• Remember that the percentages in the "IN" and
"OUT" line always refer to the momentary position
of the control stick and not to the position of the
point.
• Y-axis button (Y-axis)
Activate this function by touching the button at
the bottom edge of the display with a fi nger or the
provided stylus:
You can then move an active (red) point upward by
pressing the INC button, or downward by pressing
the DEC button, for example:
NORMAL
Graubele
ENT
+050%
+050%
+050%
2
>>
BACK
S
IN
OUT
POINT
ON
INC
DEC
Y-axis
X-axis
ST ON
ACT
CH8
CH10
ONCTL
Touch the Y-axis button to deactivate the function.
Note:
Remember that the percentages in the "IN"
and "OUT" line always refer to the
momentary position of the control stick and
not to the position of the point.
After you have fi nished making your settings, touch
the BACK button at the top left of the display to return
to the mixer selection and, if desired, further to the
menu selection:
BACK
SYSTEM
BASE
FUNCTION
Q.Link
Wing MIX
D/R,EXP
THR.CRV
Flap MIX
Aile diff
Flap sett
Prog.MIX
V-Tail
Trainer
Telemetry
Butterfly
106
Function menu - Prog.MIX
S1006_mz-24.3.en.indd 106 17.12.2014 15:21:57