Instructions for use

81 / 116
S1002.PRO_mz12PRO_Teil2_V1sh
Value Description Possible settings
LIMIT+ Limit on the "+"
side of the servo
travel in percent-
age servo travel
30 … 150 %
PERIOD Cycle time in ms 10 or 20 ms
OUTPUT CH (selected channel)
In this line, select the OUTPUT CH to be set (receiver servo connec-
tion).
Programming step-by-step
1. Select the line "OUTPUT CH" using the selection keys.
2. Push the ENT key.
The value field is displayed inverted:
3. Use the selection keys to set the desired receiver output.
4. Proceed in the same way with the remaining channels.
Reverse (servo reverse)
When the value field is active, this sets the direction of rotation of
the servo connected to the selected control channel:
Servo Reverse ON / OFF
CENTER (servo center)
In the "CENTER" line, the currently saved pulse time for the servo
center of the control channel selected in the "OUTPUT CH" line is
displayed in μs. The set channel pulse time of 1500 µs is the standard
center position and hence the normal servo center.
Programming step-by-step
1. Select the line "CENTER" using the selection keys.
2. Push the ENT key.
The value field is displayed inverted:
3. Move the corresponding control, control stick and/or trimming
control into the desired position.
4. Push the ENT key.
The actual control position is saved as the new neutral position.
TRIM (trimming position)
In the "TRIM" line, the neutral position of the control channel
selected in the "OUTPUT CH" line can be fine-tuned with the selec-
tion keys in 1 μsec steps: