Instructions for use

77 / 116
S1002.PRO_mz12PRO_Teil2_V1sh
• Changing a parameter
ശ Push the ENT key.
ശ Change the selected value with the selection buttons within
the possible setting range.
ശ Press the ENT key to accept the value.
ശ Push the ESC key to come back to the exit position.
• If, instead of a submenu but the adjacent message appears, there
is still no connection to a receiver. It is therefore necessary to
switch on the receiving system or, if necessary, to bind the receiver
again if the latter is not the "last bound".
SETTING & DATA VIEW
Note
The description of the menus summarized in this collective con-
cept is based on the characteristics of the HoTT standard receivers
and therefore applies only to them.
Special receivers, e.g. the receivers GR-18 HoTT (No. 33579) or Fal-
con 12 (No. S1035) are equipped with unique versions of the menu
"SETTING & DATA VIEW". Corresponding menu descriptions are
contained in their respective receiver instructions.
The remaining points of the "telemetry" menu as well as the "dis-
play telemetry data" described in the following section are gener-
ally valid and thus apply equally to all receivers.
RX DATAVIEW
In this display page of the submenu "SETTING & DATA VIEW" you
will not be able to make any settings. This page is for information
only:
Value Description
Vx.xx Firmware version of the receiver
S-QUA Quality expressed as a percentage of the signal
packages from the transmitter arriving at the
receiver
S-dBm Level in dBm expressed as the percentage of
the transmitter signal arriving at the receiver
S-STR Signal strength expressed in percentage of the signal
from the transmitter arriving at the receiver
R-TEM. Receiver temperature in °C
L PACK
TIME
Shows the longest time in milliseconds in which data
packages were lost when transmitting from the
transmitter to receiver
R-VOLT Current operating voltage of the receiver
CAN‘T
RECEIVE
ANY DATA
OK
TELEMETRY
SETTING & DATA VIEW
SENSOR
RF STATUS DISPLAY
SELECT ANNOUNCE
RX DATA ON
ALARM SETTING
RX DATAVIEW V6.37
S–STR100% R–TEM.+28°C
L PACK TIME 00010msec
R-VOLT :05.0V
L.R-VOLT:04.5V
S–QUA100%S–dBM–030dBM
SENSOR1 :00.0V 00°C
SENSOR2 :00.0V 00°C