Instructions for use
34 / 116
S1002.PRO_mz12PRO_Teil2_V1sh
Phase setting (helicopter)
Push the ENT key to recall the setting page of this menu.
Push the ESC key to stop the procedure.
As long as no switch is assigned to phase 2 or autorotaon phase,
the transmier is automacally in phase 1 "normal". Both the num-
ber and the name of this phase are xed and can not be changed,
which is why the «normal» phase is not displayed as phase 1, but
remains hidden.
It should also be pointed out that the phases are preceded by prior-
ies, which must be taken into account, in parcular, in the assign-
ment of individual switches. The underlying scheme can be described
as follows:
• If all the phase switches that are assigned are closed or open, the
"normal" phase is acve.
• If only one switch is closed, then the phase which is assigned to
the currently closed switch is acve.
• The "autorotation phase" ALWAYS takes precedence over all
other phases.
On the servo side, the changeover is not "hard", but with a xed
switching me of approx. 1 second.
"Phase 2" is preceded by the phase name "hover". This pre-seng
may be le or modied as follows:
Programming the phase name step-by-step
1. Push the ENT key.
2. Select a suitable phase name among the ones appearing in the
list.
3. Press the ENT key to complete the operation.
As soon as one switch is activated in the right column or in the line
"Autorotation" of the "Model type" menu, the name of the respec-
tive active phase is displayed in the basic display as well as in all
menus where phase settings are adjustable and all phase-depen-
dent settings made in the respective active phase are active.
Model type
Phase setting
Phasentrimmung
=>
=>
=>
=>
=>
Phase 2
Phase 3
hovering
Speed
–––
–––