Instructions for use
33 / 116
S1002.PRO_mz12PRO_Teil2_V1sh
Phase setting (Air, land and water models)
Push the ENT key to recall the setting page of this menu.
Push the ESC key to stop the procedure.
As long as no switch is assigned to phase 2 or phase 3, the transmit-
ter is automacally in phase 1 "normal". Both the number and the
name of this phase are xed and can not be changed, which is why
the «normal» phase is not displayed as phase 1, but remains hidden.
It should also be pointed out that the phases are preceded by prior-
ies, which must be taken into account, in parcular, in the assign-
ment of individual switches. The underlying scheme can be described
as follows:
• If all the phase switches that are assigned are closed or open, the
"normal" phase is acve.
• If only one switch is closed, then the phase which is assigned to
the currently closed switch is acve.
On the servo side, the changeover is not "hard", but with a xed
switching me of approx. 1 second.
"Phase 2" is preceded by the phase name "Start" and "Phase 3" by
the name "Speed". This pre-seng may be le or modied as fol-
lows:
Programming the phase name step-by-step
1. Select the desired value field using the selection keys.
2. Push the ENT key.
3. Select a suitable phase name among the ones appearing in the
list.
4. Press the ENT key to complete the operation.
As soon as at least one switch is activated in the right column, the
name of the respective active phase is displayed in the basic display
as well as in all menus where phase settings are adjustable and all
phase-dependent settings made in the respective active phase are
active.
Model type
Phase setting
Phase trim
=>
=>
=>
=>
=>
Phase 2
Phase 3
Start
Speed
–––
–––