Instructions for use

112 / 116
S1002.PRO_mz12PRO_Teil2_V1sh
Appendix
Firmware update
Firmware updates of the transmitter are carried out via the back
micro USB port and the setting "PC COM Port" in the transmitter
using a laptop or PC with Windows 7 ... 10.
The required programs and files are enclosed in a software pack and
can be found for the corresponding product at www.graupner.de.
Download this software package from the Internet, and unpack it on
your Windows PC or laptop.
The update is carried out via the "Firmware Upgrade" program sec-
tion of the program "Firmware_Upgrade_gr_Studio". Please follow
the notes of the software. The further procedure is also described in
detail in the manual contained in the data package. You can also sin-
gularly download these from the download page of the product at
www.graupner.de.
Notes
• Please note that compatible firmware is required for reliable
communication between the HoTT components. The programs
and files that are required for updates are therefore combined
into a single pack that is currently named "HoTT_Software_
V4.zip".
• Only operate your transmitter using the current software ver-
sion. The current firmware version can be found on the Internet
at www.graupner.de.
Transmitter software update
Perform update step by step
1. Before each update check the transmitter battery charge status.
2. Connect the back micro USB port of the switched off transmitter
through the included USB cable to a PC.
ശ Do not disconnect the link to the computer during an update!
Make sure that the link between the transmitter and com-
puter is operational.
3. Switch the transmitter on, select in "PC COM Port" in the display
and push the ENT key.
4. Select the correct COM port in the program part "Port select" of
the "Firmware_Upgrade_gr_Studio".
5. Launch the Firmware_Upgrade_gr_Studio" and store for safety
reasons all the occupied model memories through the program
part "Model Data" to be able to restore them.
6. Launch the "Firmware Upgrade" program section of the program
"Firmware_Upgrade_gr_Studio".