Instructions for use

104 / 116
S1002.PRO_mz12PRO_Teil2_V1sh
Note
To correctly display the RPM, the relevant number of blades and
the charge must be entered beforehand in the "Telemetry" menu.
Vario
This display shows the data about altitude in meters related to launch
so as the the current climb/sink rate in m/s, from the vario integrated
in the General Air Module (No. 33611) .
Speed display
In base on the related sensors this display shows the current speed
on the ground.
Air pressure display
In base on the related sensors this display shows the current air pres-
sure.
"lowest cell"
According to the availability of the corresponding sensor, this display
shows the currently lowest cell voltage of a battery pack as well as
the number of the relevant cell.
ELECTRIC AIR MODULE
These two displays visualize the data of an Electric Air Module con-
nected to the receiver (No. 33620).
Depending on the configuration of the module with additional sen-
sors, the following data can be permanently shown on the display:
The current voltage of the power source connected to the battery
connector of the module and its currently flowing current are shown
on the upper left of the current state.
In the middle, the current altitude relative to the site, the rise or fall
of the model in m / 1 s and m / 3 s, and the temperature / voltage
sensors connected to the module (No. 33612 or 33613 ) measured
current voltages of up to two accumulators (BAT1 and BAT2). In the
middle below the associated temperatures.
0.0
0
m
m
s
0
km/h
0.0
Bar
CELL0=0.00V
RX–S QUA: 100%
RX–S ST : 100%
TX–dBm: 33dBm
RX–dBm: 33dBm
RX–SPG.:4.8 TMP
V–PACK: 10ms
CH OUTPUT TYPE:ONCE
VARIO
GPS
RECEIVER
AIR ESC
GENERAL
ELECTRIC AIR
0.0V 0m/3s
BAT1 0m/1s
BAT2
0.0V T2 0°C
T1 0°C
0
1L0.00
2L0.00
3L0.00
4L0.00
5L0.00
6L0.00
ALT 0m
7L0.00
0.0V 0A
ON