User manual

ENT
ESC
TEL VIW
12. BINDING
1. With the transmitter on and the home screen displayed, press the ENT button.
2. The model men is highlighted then press the direction button to highlight RF sett.
4. After completing the bind, press the ESC button to return to the home screen.
3. Press the ENT button, the cursor is automatically on the stick mode line then press the direction
button to select the hyphen in the rx bind line. Turn on the receiver then press the ENT button on the
receiver for over 3 seconds so that the receiver enter the binding mode. Press the ENT button of the
transmitter, the system will be connected within a few seconds and the model name of the receiver
is displayed on the screen.
You must bind the receiver to the transmitter before the receiver will operate. Binding teaches
the receiver the specific code of the transmitter so that it will only connect to it’s correspond-
ing transmitter.
ENT
ESC
TEL VIW
ENT
ESC
TEL VIW
1. Model mem (Aircraft and Helicopter)
The model mem (model memory) contains 4 categories: select model, model name, clear
model and copy model.
Select model :
It is used to add or select model of the already set 10 models.
Model name : The Model Name function allows you to name a model. This makes identifying and
selecting models much easier.
Clear model : Clear Model is used to remove the programmed model you will no longer be ying. No
other model memories will be affected.
Copy mod->mod : Copy model function copies the currently selected model’s programmed value to
another model list.
• The Transmitter Programming Setup
8
ENT
ESC
TEL VIW
ENT
ESC
TEL VIW
ENT
ESC
TEL VIW
ENT
ESC
TEL VIW
press
press
press
ENT
ESC
TEL VIW
press
press