User manual

- PERIOD

The servo response time for transmitter throttle can be adjusted. All channels that servo connect-

ed are applied separately. Press DOWN button to access to PERIOD line then press ENT button

to highlight the default value 20msec. Press UP/DOWN button to set 10msec or 20msec and then

press ENT button to remove the highlight.

OUTPUT CH (receiver)/ INPUT CH (transmitter): It is used to perform the programming setup of

transmitter channel that is bound to receiver. The default setup is that each channel 1,2,3,4,5,6 of

receiver is connected to the same channel 1,2,3,4,5,6 of transmitter. In case that R16, 16 channel

receiver, is bound to mz-12, 6 channel transmitter, this function is very useful. For example, 4 aile,

4 ap are used in aircraft, 1~4 channels can be set to aile and 5~8 channels can be set to ap and

then other channels can be set to elev or rudd. Press the direction button at EX SERVO mode to

go to RX FAIL SAFE mode. OUTPUT CH line has been selected at RX FAIL SAFE mode. Press

ENT button to highlight the default value 1. Press UP/DOWN button to select the desired channel

and then press ENT button to remove the highlight. Press DOWN button to access to INPUT CH

line. Press ENT button to highlight the default value 1. Press UP/DOWN button to select the de-

sired channel that is connected INPUT CH and then press ENT button to remove the highlight.

16-3. RX FAIL SAFE

ENT

ESC

TEL VIW

ENT

ESC

TEL VIW

ENT

ESC

TEL VIW

ENT

ESC

TEL VIW

ENT

ESC

TEL VIW

ENT

ESC

TEL VIW

ENT

ESC

TEL VIW

ENT

ESC

TEL VIW

ENT

ESC

TEL VIW

press

press press