User manual

- LIMIT + / -
The maximum value for each direction can be programmed so that the maximum servo travel limit
of the connected servo is adjusted. The default value is 150% but the servo travel range is limited
to 100% that is programmed at SERVO EPA of transmitter so the servo limit is not operated at
150% ~ 100%, but operated at below 100%. If SERVO EPA of transmitter is set to 150%, the LIM-
IT value can be set below 150%. Press DOWN button to access to LIMIT+/- line then press ENT
button to highlight the default value 150%. Press UP/DOWN button to program the desired value
and then press ENT button to remove the highlight.
56
ENT
ESC
TEL VIW
ENT
ESC
TEL VIW
ENT
ESC
TEL VIW
ENT
ESC
TEL VIW
ENT
ESC
TEL VIW
press
press
- CENTER
The value of servo center in the selected channel at OUTPUT CH can be programmed. The
center value depends on transmitter throttle and trim position. General servo center value is
1500us. Press DOWN button to access to CENTER line then press ENT button to highlight the
default value 1500usec. Move and hold transmitter throttle at the desired position then press ENT
button, the center value corresponding to throttle position is set.
- TRIM
the servo trim can be set. Press DOWN button to access to TRIM entry then press ENT button to
highlight the default value -000usec. Press UP/DOWN button to program the desired value and
then press ENT button to remove the highlight.
ENT
ESC
TEL VIW
ENT
ESC
TEL VIW
ENT
ESC
TEL VIW
ENT
ESC
TEL VIW
ENT
ESC
TEL VIW
press
press
press
press press
press