User manual

This function allows you to perform servo programming set up at the entries of OUTPUT CH RE-
VERSE, CENTER, TRIM, LIMIT-, LIMIT+, PERIOD. Press the direction button on RX DATA VIEW
mode to access to RX SERVO then press DOWN button to select the desired article. Press ENT
button to highlight the value on the selected article, you may change to the desired value.
- OUTPUT CH
The receiver output channel can be selected. Press ENT button to highlight the value and press UP/
DOWN buttons to set the desired value. Press ENT button to remove the highlight.
16-2. RX SERVO
- REVERSE
It is used to decide the direction of servo rotation. Press DOWN button to access to REVERSE
line then press ENT button to highlight the default value OFF. Press UP/DOWN button to select
ON or OFF. Press ENT button to remove the highlight.
55
ENT
ESC
TEL VIW
ENT
ESC
TEL VIW
ENT
ESC
TEL VIW
ENT
ESC
TEL VIW
ENT
ESC
TEL VIW
ENT
ESC
TEL VIW
ENT
ESC
TEL VIW
ENT
ESC
TEL VIW
ENT
ESC
TEL VIW
ENT
ESC
TEL VIW
press
press
press
press
press
press
ENT
ESC
TEL VIW
press
press
press