User manual

- Receiv out
Press the direction button to select the receiv out line then press the ENT button to access the
function. The cursor is on the arrow mark then press the ENT button to access the function.
The default channe l assignm ent ap pear s on t he sc reen.
Press the direction button to select S1~S6 then press the ENT
and the direction buttons to highlight and change to the desired
channel. Press the ESC button to get back to the previous
screen.
NOTE: If yo u cha nge S1 to S 2, th e S2 have t he 2 c hann els of
output 1 and output 2 so the both servo of output 1 and output 2
are simultaneously moved when the stick of the S2 is move.
- Rx bind
Press the direction button to select rx bind line then the cursor is at the hyphen. Turn on the re-
ceiver then press the ENT button on the receiver for over 3 seconds so that the receiver enter the
binding mode. Press the ENT button of the transmitter, the system will be connected within a few
seconds and the model name of the receiver is displayed on the screen after completing the bind.
- Range test
Press the direction button to select the range test, the cursor is at the 99sec. Turn on the receiver
then press the ENT button on the transmitter. With the range test started, the Graupner/SJ logo
blinks with beep for 99sec. Walk over 50 meters away from the model with controlling the trans-
mitter sticks constantly and check whether the model is operating normally. You should have total
control of the model with the trainer switch pulled.
29
ENT
ESC
TEL VIW
ENT
ESC
TEL VIW
ENT
ESC
TEL VIW
ENT
ESC
TEL VIW
ENT
ESC
TEL VIW
ENT
ESC
TEL VIW
ENT
ESC
TEL VIW
ENT
ESC
TEL VIW
ENT
ESC
TEL VIW
ENT
ESC
TEL VIW
press
press
press
press
-The default channel assignment-
Channel
Throttle S1
S2
S3
S4
S5
S6
Aileron
Elevator
Rudder
5 Channel
6 Channel
Output
Output 1
Output 2
Output 3
Output 4
Output 5
Output 6
press
press