User manual

6. RF sett (Aircraft and Helicopter)

The RF function of the transmitter can be programmed, it contains 6 models of stick mode, timer,

receiv out, rx bind, range test, RF transmit.

Stick mode

The mz-12 has four stick modes with the two dual axis sticks. The user can select one among the

four default stick modes the default mode is the mode 1.

•

Timer

The mz-12 has four stick modes with the two dual axis sticks. The user can select one among the

four default stick modes the default mode is the mode 1.

•

Receiv out

For the maximum exibility of the receiver socket assignment, the mz-12 provides to swap over the

servo outputs 1 to max.6. If you try to use more than 1 servos at the aileron or the elevator or the

rudder, the receiver output socket can be assigned as you intend.

•

Rx bind : The receiver must be bound to the transmitter before the receiver will operate. Binding

teaches the receiver the specic code of the transmitter, so it will only connect to that transmitter.

•

Range test : The Range Test function reduces the power output. This allows for a range test to con-

rm the RF link is operating correctly. Perform a range check at the beginning of each ying session to

conrm system operation.

•

RF transmit : RF transmit function allows to turn on/off the RF power output

ENT

ESC

TEL VIW

ENT

ESC

TEL VIW

ENT

ESC

TEL VIW

ENT

ESC

TEL VIW

ENT

ESC

TEL VIW

ENT

ESC

TEL VIW

ENT

ESC

TEL VIW

press