User manual

ManualsBrandsGRAUPNER ManualsModel Making Remote ControlsMZ-12 HoTT Handheld RC 2,4 GHz No. of channels: 6 Incl. receiver

4. Cont sett (Aircraft and Helicopter)

It contains 3 categories: model type, quick link set and quick link trim. You can program the 5 and 6

channels in mz-12 to the special function that you want. Typically, the 5 channel is used for the on/

off switch of the retractor gear and the 6 channel is used for the on/off switch of the ap function. The

special 2 channels are widely used, depending on the airplane wing type.

- Cont sett (AIRCRAFT)

Press the direction button to highlight the cont sett then press the ENT button to access the function.

The cursor is at the free of I5 line. Press the ENT button then the pop up message “operate desired

switch or control” appears. Move the switch or the volume that you want to use, then they are set to the

special channels. Here is the example that the NO.3 switch is set. Press the direction button to select

the trv value then press the ENT button. Both of – value and + value are simultaneously highlighted.

Press the direction button to adjust the desired value (If you press the VIW button, you can check

the adjusted value) then press the ESC button to get back to the menu screen. The 6 channel can be

programmed with the same method with the channel 5.

NOTE : If you move the switch or volume that is designated as the special channel, the cursor is

moved to the corresponding value then you can adjust each of – value and + value. Press the ENT to

highlight the value then press the direction buttons to adjust the desired the value.

ENT

ESC

TEL VIW

ENT

ESC

TEL VIW

ENT

ESC

TEL VIW

ENT

ESC

TEL VIW

ENT

ESC

TEL VIW

ENT

ESC

TEL VIW

ENT

ESC

TEL VIW

ENT

ESC

TEL VIW

ENT

ESC

TEL VIW

ENT

ESC

TEL VIW

press

ENT

ESC

TEL VIW

press