Operation Manual

English
English
INNOVATION & TECHNOLOGIE
42 43
Menu SETTINGS
In this menu, you have the opportunity not only to update the date and time, but also to customize
the default settings of the charger.
Please note in this context that the parameter values of this rst display “USER SETUP”
act on a specic channel, and therefore CH1 and CH2 must be set separately, while the
parameters of the displays 2 to 4 act on specic devices. Therefore, these displays are
also available only on the menu “SETTINGS” of the charge channel CH1 and at the same place in
CH2 they are hidden.
1. Display “USER SETUP“
Parameter* Short description
Ready sound 10 different melodies adjustable
Sound time Melody period (on, off, 5 s, 15 s and 1 Minute)
Beep IN = Buzzer (light), OUT = Speaker (loud), OFF
LCD bright Display brightness (range 1 … 20)
Temperature
Unit
Unit of temperature (°C / °F)
Volume Volume of the tone(1 … 5)
* Displaysthefactorysettingvaluesshowninthegure.
2. Display “POWER SETTINGS“
1 Input 1 (actually active)
2 Input 2 (actually passive)
3 Input power per input resulting from the settings 4 and 5
4 Set the maximum input voltage (range 12 ... 28 V)
5 Set the maximum input current (range 5 ... 50 A)
6 Undervoltage warning threshold (range 10.7 ... 28 V)
7 Output 1 (CH1)
8 Output 2 (CH2)
9 Output power per output resulting from the maximum charge distribution 10
10 Distribution in%
ATTENTION!
Protect your power source, but especially your car battery, to the possibility of
overloading by specifying the corresponding input limits.
“DATA VIEW” of the “EXT MODULE “ appears on the display of the Graupner polaron EX-1400:
Control Function
Up Moves the cursor “>“ at the beginning of a line of data pages
step upward or increase a value in an active value eld
Down Moves the cursor “>” at the beginning of a line of data pages
step back or a reduced value in an active value eld
SET Activates and deactivates value elds
DEC Scrolls one page back
INC Scrolls one page forward
• The data shown in the display depend on the connected device. Consult the instruction
manual supplied with your esc for more informations.
• For technical reasons, the transmission of telemetry data occurs only at certain time intervals.
For these reasons there may be a delayed reaction between buttons input and setting changes.
This is therefore not due to an error.