Operation Manual

ENT
ESC
TEL VIW
ENT
ESC
TEL VIW
press
CH OUT TYPE
You may decide the signal output type of receiver. 5 types of ONCE / SAME / SUMO12/
SUMI / SUMD HD12 are available.
- ONCE
It is use for analogue servo. If ONCE is selected, PERIOD on RX SERVO is set to
20msec automatically.
- SAME
It is use for digital servo. If SAME is selected on CH OUT TYPE line, you need to set
PERIOD on RX SERVO to 10 ~ 20msec. when analogue servo is used, 20mse should
be set.
- SUMI
Receiver get the signal of the receiver performed the SUMO programming setup then
outputs the signal
- SUMD HD
The digital output signal of all channels in receiver is outputted from the selected channel.
It is used to the product that needs the receiver digital signal such as Power box and Flybar-
less system. The factory default for SUMD HD output channel is the last channel of receiver
and you may change it.
- SUMO
Only the selected channel outputs the signal of all channels of receiver. In case that 1
receiver is set to SUMO and the other receiver is set to SUMI and then they are connect-
ed in ex code, the receiver set to SUMI outputs the signal came from the receiver set to
SUMO. The nal channel of receiver is set to SUMO output channel, but you may change
to the desired channel.
Press DOWN buttons to access CH OUTPUT TYPE and press ENT button then the
default value SAME is highlighted. Press UP/DOWN buttons to set the desired value and
press ENT button to remove the highlight. When you select SUMO 12 and SUMD HD12
and try to select the different output channel, press ENT button to move the highlight to 12
then press UP/DOWN button to select the desired channel. Press ENT button to remove
the highlight.
ENT
ESC
TEL VIW
press
ENT
ESC
TEL VIW
ENT
ESC
TEL VIW
press
ENT
ESC
TEL VIW
press
ENT
ESC
TEL VIW
press
ENT
ESC
TEL VIW
press
press
68