Operation Manual

- PERIOD

The servo response time for transmitter throttle can be adjusted. All channels that servo

connected are applied separately. Press DOWN button to access to PERIOD line then

press ENT button to highlight the default value 20msec. Press UP/DOWN button to set

10msec or 20msec and then press ENT button to remove the highlight.

OUTPUT CH (receiver)/ INPUT CH (transmitter): It is used to perform the programming

setup of transmitter channel that is bound to receiver. The default setup is that each channel

1,2,3,4,5,6 of receiver is connected to the same channel 1,2,3,4,5,6 of transmitter. In case that

R16, 16 channel receiver, is bound to mz-12, 6 channel transmitter, this function is very useful.

For example, 4 aile, 4 ap are used in aircraft, 1~4 channels can be set to aile and 5~8 chan-

nels can be set to ap and then other channels can be set to elev or rudd. Press the direction

button at EX SERVO mode to go to RX FAIL SAFE mode. OUTPUT CH line has been selected

at RX FAIL SAFE mode. Press ENT button to highlight the default value 1. Press UP/DOWN

button to select the desired channel and then press ENT button to remove the highlight. Press

DOWN button to access to INPUT CH line. Press ENT button to highlight the default value 1.

Press UP/DOWN button to select the desired channel that is connected INPUT CH and then

press ENT button to remove the highlight.

16-3. RX FAIL SAFE

ENT

ESC

TEL VIW

ENT

ESC

TEL VIW

ENT

ESC

TEL VIW

ENT

ESC

TEL VIW

ENT

ESC

TEL VIW

ENT

ESC

TEL VIW

ENT

ESC

TEL VIW

ENT

ESC

TEL VIW

ENT

ESC

TEL VIW

press

press press