Operation Manual

This function is used to program receiver and telemetry sensor and get the data information

on them. This function can be accessed only if transmitter and receiver are bound. If not,

when the function is accessed, the error message “CAN’T RECIVE DATA OK” is appeared.

Press ENT button to access RX DATA VIEW, you may program and get the data information

on receiver data. If telemetry sensor is connected to receiver, you may also program and

get the data information on telemetry sensors.

This function allows you to get the data information on receiver.

16. SETTING & DATA VIEW

16-1. RX DATA VIEW

ENT

ESC

TEL VIW

ENT

ESC

TEL VIW

ENT

ESC

TEL VIW

ENT

ESC

TEL VIW

press

Telemetry is used to perform HoTT telemetry programming setup and check HoTT telemetry

data. 4 functions of SETTING & DATA VIEW, SENSOR SELECT, RF STATUS VIEW and

VOICE TRIGGER are available. Press TEL button to go to the start up page of telemetry.

SETTING & DATA VIEW has been selected on the start up page. Whenever your press

DOWN button, 4 functions is selected in turn.

15. Telemetry

press

ENT

ESC

TEL VIW

ENT

ESC

TEL VIW

ENT

ESC

TEL VIW

ENT

ESC

TEL VIW

ENT

ESC

TEL VIW

press