Operation Manual

ManualsBrandsGraupner ManualsMiscellaneousMZ-12 HoTT - S1002

- Receiv out

Press the direction button to select the receiv out line then press the ENT button to access the

function. The cursor is on the arrow mark then press the ENT button to access the function.

T h e d e f a u l t c h a n n e l a s s i g n m e n t a p p e a r s o n t h e s c r e e n .

Press the direction button to select S1~S6 then press the

ENT and the direction buttons to highlight and change to

the desired channel. Press the ESC button to get back to

the previous screen.

NOTE: If you change S1 to S2, the S2 have the 2 chan-

nels of output 1 and output 2 so the both servo of output

1 and output 2 are simultaneously moved when the stick

of the S2 is move.

- Rx bind

Press the direction button to select rx bind line then the cursor is at the hyphen. Turn on the

receiver then press the ENT button on the receiver for over 3 seconds so that the receiver

enter the binding mode. Press the ENT button of the transmitter, the system will be connect-

ed within a few seconds and the model name of the receiver is displayed on the screen after

completing the bind.

- Range test

Press the direction button to select the range test, the cursor is at the 99sec. Turn on the re-

ceiver then press the ENT button on the transmitter. With the range test started, the Graupner

logo blinks with beep for 99sec. Walk over 50 meters away from the model with controlling the

transmitter sticks constantly and check whether the model is operating normally. You should

have total control of the model with the trainer switch pulled.

ENT

ESC

TEL VIW

ENT

ESC

TEL VIW

ENT

ESC

TEL VIW

ENT

ESC

TEL VIW

ENT

ESC

TEL VIW

ENT

ESC

TEL VIW

ENT

ESC

TEL VIW

ENT

ESC

TEL VIW

ENT

ESC

TEL VIW

ENT

ESC

TEL VIW

press

-The default channel assignment-

Channel

Throttle S1

Aileron

Elevator

Rudder

5 Channel

6 Channel

Output

Output 1

Output 2

Output 3

Output 4

Output 5

Output 6

press