Operation Manual

6. RF sett (Aircraft and Helicopter)
The RF function of the transmitter can be programmed, it contains 6 models of stick mode,
timer, receiv out, rx bind, range test, RF transmit.
• Stick mode
The mz-12 has four stick modes with the two dual axis sticks. The user can select one among
the four default stick modes the default mode is the mode 1.
• Timer
The mz-12 has four stick modes with the two dual axis sticks. The user can select one among
the four default stick modes the default mode is the mode 1.
• Receiv out
For the maximum exibility of the receiver socket assignment, the mz-12 provides to swap over
the servo outputs 1 to max.6. If you try to use more than 1 servos at the aileron or the elevator or
the rudder, the receiver output socket can be assigned as you intend.
• Rx bind : The receiver must be bound to the transmitter before the receiver will operate. Binding
teaches the receiver the specic code of the transmitter, so it will only connect to that transmitter.
• Range test : The Range Test function reduces the power output. This allows for a range test to
conrm the RF link is operating correctly. Perform a range check at the beginning of each ying
session to conrm system operation.
• RF transmit : RF transmit function allows to turn on/off the RF power output
ENT
ESC
TEL VIW
ENT
ESC
TEL VIW
ENT
ESC
TEL VIW
ENT
ESC
TEL VIW
ENT
ESC
TEL VIW
ENT
ESC
TEL VIW
ENT
ESC
TEL VIW
press
press
press
29