Operation Manual

- Quick link sett
The quick link sett function allows to adjust the quick2 value and assign the corresponding
switch to cope with various ight conditions such as 3D ight or the ight with the strong wind.
Since the adjusted value is activated by moving the switch, you can cope with various ight
conditions with switch. It makes you operating the ight much easier.
You can select hover, acro, acro 3D, speed and test at the quick2 line.
Press the direction button to select the quick link sett line then press the ENT button to access
the function. The cursor is on the default value, hover, in the quick 2 line then press the ENT
button to highlight. Press the direction button to select the desired value then press the ENT
button to remove the highlight. Press the direction button to select the hyphen then press the
ENT button. The popup message “push desired switch into position ON” appears. Move the
switch to the desired position then the corresponding value appears. Press the ESC button to
get back to the m.type + quick screen. The quick link function is connected to the D/R expo and
the heli mix functions so the different value of the normal and quick2 can be programmed to
the D/R expo and the heli mix functions.
ENT
ESC
TEL VIW
ENT
ESC
TEL VIW
ENT
ESC
TEL VIW
ENT
ESC
TEL VIW
ENT
ESC
TEL VIW
ENT
ESC
TEL VIW
ENT
ESC
TEL VIW
ENT
ESC
TEL VIW
ENT
ESC
TEL VIW
ENT
ESC
TEL VIW
press
press
press
ENT
ESC
TEL VIW
ENT
ESC
TEL VIW
press
press
press
press
press
press
press
23