Operation Manual

- Cut off
Press the direction button to select the cut off line then press the ENT and the direction
button to highlight and adjust the value less than -100%. Press the ESC button to remove
the highlight.
NOTE : The value of -100% is the cut off position the user can program, if the cut off value
is programmed less than -100%, the breathing hole of Engine carburetor is block or the
speed controller lets the motor off so the power is not delivered to the Helicopter.
Press the direction button to select +150% in the value.
Place the throttle stick at the desired position and press the ENT button then adjusted
value is applied (The adjusted value is activated when the throttle stick is in that position).
NOTE : the value of +150% is the throttle stick position where the cut off function is
activated.
Press the direction button to select the hyphen then press the ENT button. The popup
message“push desired switch into position ON”appears then move the switch to the desired
position (The cut off function is activated when the switch is moved to that position)
ENT
ESC
TEL VIW
ENT
ESC
TEL VIW
ENT
ESC
TEL VIW
ENT
ESC
TEL VIW
ENT
ESC
TEL VIW
ENT
ESC
TEL VIW
ENT
ESC
TEL VIW
ENT
ESC
TEL VIW
ENT
ESC
TEL VIW
press
press
ENT
ESC
TEL VIW
ENT
ESC
TEL VIW
press
press
press
press
press
press
21