Operation Manual

61
Fixed-wing models: receiver assignment
Installation notes
The servos MUST be connected to the receiver
outputs in the following order:
Outputs not required are simply left vacant.
Please note the following points in particular:
If you are using only one aileron servo, receiver •
output 5 (right aileron) is left unused; it can also be
used for another purpose if you select “1 AIL” in the
“Base settings” menu.
If you are using only one flap servo, receiver output 7 •
(right flap) MUST be left unused, assuming that you
have selected “2 FL” in the “Base settings” menu.
Please also read the information on the following
pages.
Receiver socket assignment for models with up to two ailerons and two flaps, plus “normal” tail type, V-tail,
and two elevator servos (3 + 8)
Servo
4 8 V
C 577
Bes Nr 4101
Receiver battery
Switch harness
Telemetry sensor
Y-lead,
Order No. 3936.11
Receiver
3 = Elevator / left V-tail
2 = Aileron / left aileron
8 = 2nd elevator / aux. function
7 = Right flap / reserve
5 = Right aileron / reserve
4 = Rudder / right V-tail
1 = Throttle / brake
6 = Flap / left flap / reserve