Operation Manual

30
Description of transmitter - Telemetry data display
As described on page 150, as part of the “SENSOR
SELECT” sub-menu of the “Telemetry” menu …
SENSOR SELECT
RECEIVER
GENERAL MODULE
VARIO MODULE
ELECTRIC AIR.MOD
GPS
… the graphic displays of one or more sensors can be
activated.
The “Receiver” display, and other graphic displays
activated in accordance with your choice of sensors, is
accessed from the transmitter’s base display by briefly
pressing the  or  button of the left or right-hand
touch-key:
RX–S QUA: 100%
RX–S ST : 100%
TX–dBm: 33dBm
RX–dBm: 33dBm
RX–VOLT:4.8 TMP
L–PACK: 10ms
R–LOW V:4.6 +22°C
You can switch between the displays for the sensors
activated in the “SELECT SENSOR” sub-menu of the
“Telemetry” menu by briefly pressing one of the arrow
buttons  of the left or right-hand touch-key …
GENERAL
ELECT. AIR
VARIO
GPS
RECEIVER
Telemetry data display
… and selecting the line for the desired sensor after
superimposing the Select window by pressing one of
the two  buttons. If no sensor is currently active, all
the other displays / sensors described in the following
section are suppressed from the Select list, with the
exception of the “RECEIVER” display, which is described
in the next column:
RECEIVER
If you wish, you can confirm your choice immediately
after this by pressing the central SET button of the
right-hand touch-key; alternatively you can simply wait
until, after a brief interval, the selected display appears
automatically.
Note:
The displays are described below in the sequence which
occurs when you press the  button.
For more information on these modules please see the
Appendix, or refer to the product on the Internet at www.
graupner.de.
RECEIVER
RX–S QUA: 100%
RX–S ST : 100%
TX–dBm: 33dBm
RX–dBm: 33dBm
RX–VOLT:4.8 TMP
L–PACK: 10ms
R–LOW V:4.6 +22°C
This screen displays the data which can also be viewed
in the “RX DATAVIEW” screen of the telemetry menu
“SETTING & DATA VIEW” (see page 138), but in
graphic form.
The meanings are as follows:
Value Explanation
RX-S QUA Signal quality in %
RX-S STR Signal strength in %
RX-dBm Receive performance in dBm
TX-dBm Transmit power in dBm
L-PACK Shows the longest period in ms
in which data packets were lost in
transmission from transmitter to
receiver
RX-VOLT Actual receiver operating voltage in
Volts
R-LOW V Lowest receiver operating voltage in
Volts since the last time it was switched
on
TMP The thermometer indicates the
receiver’s current operating
temperature