Operation Manual

13
Description of radio control set
Specification, mx-16 HoTT transmitter
Frequency band 2,4 … 2,4835 GHz
Modulation FHSS
Transmitter power see Country setting, page 135
Control functions Eight functions; four with trims
Temperature range -10 … +55°C
Aerial folding
Operating voltage 3,4 … 6 V
Current drain approx. 180 mA
Dimensions approx. 190 x 195 x 90 mm
Weight approx. 770 g with transmitter
battery
Accessories
Order No. Description
1121 Neckstrap, 20 mm wide
70 Neckstrap, 30 mm wide
3097 Wind-shield for hand-held transmitter
Trainer leads for mx-16 HoTT:
see page 157
Replacement parts
Order No. Description
2498.4FBEC 4NH-2000 RX RTU, flat-pack
33800 HoTT transmitter aerial
Specification, GR-16 HoTT receiver
Operating voltage 3,6 … 8,4 V*
Current drain ca. 70 mA
Frequency band 2,4 … 2,4835 GHz
Modulation FHSS
Aerial Diversity aerials,
2 x approx. 145 mm long,
approx. 115 mm encapsu-
lated and approx. 30 mm
active
Servo sockets 8
Sensor socket 1
Temperature range approx. -10° … +55°C
Dimensions approx. 46 x 21 x 14 mm
Weight approx. 12 g
* The permissible operating voltage range stated above applies to
the receiver only! Please note in this regard that the receiver’s input
voltage is passed directly (i.e. unregulated) to the servo sockets, but
the permissible operating voltage range of the overwhelming major-
ity of servos, speed controllers, gyros etc. which can be connected
to the receiver is only 4.8 to 6 Volt!
The set Order No. 33116 contains
mx-16 HoTT micro-computer transmitter with integral
4NH-2000 RX RTU flat-pack NiMH transmitter battery,
Order No. 33116.2 (specification reserved), plug-type
battery charger (5,6 V / 200 mAh), Graupner|SJ GR-16
HoTT bi-directional receiver, Order No. 33508, micro-SD
card, USB interface, Order No. 7168.6 and adapter lead,
Order No. 7168.6S.
Recommended battery chargers (optional)
Order
No. Description
220 V mains conn. 12 V DC connect.
Suitable for
the following
battery types
Integral charge. lead NiCd NiMH LiPo Lead-ac.
6411 Ultramat 8 x x x x x
6463 Ultramat 12 plus x x x x x x
6464 Ultramat 14 plus x x x x x x x
6466 Ultra Trio plus 14 x x x x x x x
6468 Ultramat 16S x x x x x x x
6469 Ultra Trio Plus 16 x x x x x x
6470 Ultramat 18 x x x x x x x
6475 Ultra Duo Plus 45 x x x x x x x
6478 Ultra Duo Plus 60 x x x x x x x
6480 Ultra Duo Plus 80 x x x x x x x
To charge the batteries you will also need the transmitter charge lead,
Order No. 3022 and the receiver charge lead, Order No. 3021.
For details of additional battery chargers, and details of the chargers
listed here, please refer to the main Graupner FS catalogue, or our
Internet site at www.graupner.de.
For information on additional accessories please refer to
the Appendix or visit our Internet site at www.graupner.
de. Alternatively you can enquire at your local model
shop, where the staff will be pleased to advise you.