Operation Manual

Accessories for Transmitters
94 Supplement
Flexible Antenna
Flexible short antenna for optimal freedom
of movement and unrestricted use of the
transmitter. The radiation achieved is
similar to that of the telescopic antenna at
full length. For models needing high safety
requirements, e.g. for speed and large-
scale models and for longer distances, you
should use the telescopic antenna supplied
with the transmitter.
Dimensions max, ca. 400 mm
Part No. 1149.35 for 35MHz band
.40 for 40MHz band
Push Button
Part No. 4144*
With pressure on the button the switch is
operated and it releases to the "off" only
when pressing the button again position.
The Push Button can be changed, by
removing a locking link, to a momentary
button, where the function remains "on"
only whilst the button is pressed.
HF Transmitter Module (shown on page 11)
Part No. 4824.35 for 35MHz band
4824.40 for 40MHz band
For technical data see page 99.
By fitting the appropriate quartz crystal the
frequency channel is selected. The crystal
inserted in the transmitter must carry the
same channel number as that inserted in
the receiver.
Only original GRAUPNER FMsss quartz
crystal should be used (see page 98)!
2 Function Stick Switch
Part No. 4143*
A control stick with a single pole for
operating 2 functions. For special
applications, particularly for competition
pilots.
3 Function Stick Switch
Part No. 4113*
A control stick with an integral switch with
centre-off position for operating 3
functions.
Suitable for special functions, e.g. for high-
speed and F3B-models to switch between
start, neutral and speed settings or with
F3E models as a motor switch for off, half
and full throttle.
Rotary Proportional Control Stick
Part No. 4112*
A rotary proportional control integrated in a
control stick for trim and setting functions,
or as automatic an engine speed
controller. It is also usable for similar
special functions.
*Installation has to be made by a
GRAUPNER service centre.