Operation Manual
9- 20
GR-10C_jh_V1
Telemetry or channel (T/9) socket
The optional telemetry sensors are connected to the socket
marked “T” (T/9)- Telemetry. In addition, the update is performed
on this socket. The socket can even be used as optional chan-
nel 9. (see following section)
Power supply
Connect the power supply to the battery port.
Make sure that the polarity is correct!
The input voltage should not be higher than 8,4V. (1 -2 S)
Receiver setup menu
The receiver setup menu appears in the “Telemetry“ menu under
SETTINGS / DISPLAYS or if you are using a SMART-BOX under
SETTING & DATAVIEW. How to access this menu is described
in the operating instructions supplied with your transmitter or
Smart-Box.
ALARM VOLT (receiver low voltage warning)
If the receiver voltage falls below the set value, a low-voltage
warning is generated by the transmitter's RF module in the form
of a "general alarm tone" (regular beeping at a rate of approx.
one beep per second) or the "receiver voltage" speech output
message.
(ALARM TEMP): Temperature warning
If the receiver temperature exceeds the set temperature, a warn-
ing is generated by the transmitter’s RF module in the form of a
"general alarm tone" (regular beeping at a rate of approx. one
beep per second) or the "receiver temperature" speech output
message.
Cycle time (PERIOD)
If your system is used exclusively with digital servos, you can set
a cycle time (frame rate) of 10 ms. If your system includes some
or uses exclusively analogue servos, you should always select
20 ms, as many analogue servos cannot process the higher
frame rate and may respond by "jittering" or "growling". Not
important for connected speed controllers.
(Sensor at CH9):Telemetry sensor
This socket allows you to use either for telemetry or for an extra
channel (9). (Attention! Both together is not possible!) Switching
is done in this menu item. If you select “Yes”, the socket is con-
nected to the connection of a sensor. If you select “No” a jack
is connected to the control channel 9.
Language
Here you can set the display language in the receiver menu.
Select: German, English, French, Italian, Spanish.
RECEIVER 1.0 >
>ALARM VOLT: 3,8V
ALARM TEMP: 70° C
>CYCLE: 20ms
Sensor at CH9: No
LANGUAGE: English
Setting necessary when servos
are installed for additional
functions