User Manual

24 / 76
13410_13410.100_HU_V.1
Deactivate the brake
1. Move the throttle stick to the full throttle position and connect
the drive battery, the motor plays the melody "Do Re Mi".
2. After 2 seconds the motor beeps with 2 long sounds (B-- B--)
then the controller is in the programming mode. If you move the
throttle stick to the stop position within the next 2 seconds after
the short tone (B), the controller has detected the deactivation
of the brake.
3. After a long (B--) and a short one (B) the setting is completed and
the controller is ready to start.
Activate the brake
1. Move the throttle stick to the full throttle position and connect
the drive battery, the motor plays the melody "Do Re Mi".
2. After 2 seconds the motor beeps with 2 long sounds (B-- B--)
then the controller is in the programming mode. Wait for the
short tone (B) which deactivates the brake then the tone follows
with 2 short (B B) and the brake is activated. If you move the
throttle stick to the stop position within the next 2 seconds after
the short tone (B B), the controller has detected the activation
of the brake.
3. After a long (B--) and two short ones (B B) the setting is com-
pleted and the controller is ready to start.
Switch-on the receiver
1. Ensure that the throttle stick is always in the motor stop position
when the drive battery is connected
2. Connect the drive battery to the plug of the controller, the motor
plays the melody "Do Re Mi"
3. After 2 seconds, the motor beeps with a long tone (B--), which
means that the throttle stick is in the motor stop position for a
safe start.
4. After 2 seconds, the motor emits the tones of the set braking
function.
5. Now the controller is ready to operate the motor.