User manual

142
Program description: Info display
Info Display
Date, time, transmitter ID and memory card
Use the arrow buttons of the left or right-hand four-way
button to leaf through to the “info disp” menu point of the
multi-function menu:
servo set.
D/R expo
wing mixer
contr set.
phase trim
free mixer
servo disp basic sett
fail-safe
telemetry
teach/pupi info disp
servo set.
D/R expo
free mixer
contr set.
heli mixer
swashp.mix
servo disp basic sett
fail-safe telemetry
teach/pupi info disp
Press the central SET button of the right-hand four-way
button to open the men
u point:
RFID
firmware ver.
SD-CARD
1.11
0MB
ABCDEF12
available
0MB
0%
This menu displays transmitter-specifi c information,
some of which can be altered where necessary and
sensib
le.
Use the arrow buttons cd of the left or right-hand four-
way button to select the appropriate line, then press the
central SET button of the right-hand four-way button. In
the highlighted value fi
eld you can now alter the default
value using the arrow buttons of the right-hand four-way
button, and conclude your input with a further press of
the central SET key.
RFID
RFID
firmware ver.
SD-CARD
1.11
0MB
ABCDEF12
available
0MB
0%
This line displays the transmitter’s identifi cation number.
This number is specifi
c to the transmitter, and is only
issued once for each transmitter. During the binding
process this ID is transmitted to the receiver (amongst
other data), so that it is able at any time to identify the
radio signals of “its” transmitter.
Firmware version
RFID
firmware ver.
SD-CARD
1.11
0MB
ABCDEF12
available
0MB
0%
This line displays the version number of the transmitter
software currently installed.
By compar
ing the number shown here with the update
version available for the same product on the Internet
at www.graupner.de you can judge whether an update
to the transmitter’s operating system is necessary and
useful.
In some circumstances our Service department may
also ask you for the version number.
SD card
RFID
firmware ver.
SD-CARD
1.11
2048MB
ABCDEF12
available
1234MB
60%
This line displays the storage capacity in MB of a
memory card installed in the tr
ansmitter.
Depending on the memory capacity of the micro-SD
or micro-SDHC memory card fi tted in the transmitter,
it may take several minutes for the display to show the
correct value after you switch the transmitter on.
available
RFID
firmware ver.
SD-CARD
1.11
2048MB
ABCDEF12
available
1234MB
60%
Display of the available memory in MB.
As already mentioned, it may tak
e a certain amount of
time for the available memory to be displayed after you
switch the transmitter on, depending on the total capac-
ity of the installed memory card.
The next line down displays the available memory in
relation to the total memory capacity: