Instructions for use GRP-2054

[Seite 8]
The following parts are also required
(included in the kit):
2 M4 x 8.0 mm socket-head cap screws: motor mounting
2 M3 x 8.0 mm socket-head cap screws: motor mounting
4 2.9 Ø x 9.5 mm self-tapping screws: rudder mounting
4 2.2 Ø x 6.5 mm self-tapping screws: servo mount
2 2.2 Ø x 6.5 mm self-tapping screws: servo mounting
3 2.2 Ø x 6.5 mm self-tapping screws: turn fin mounting
2 2.2 Ø x 6.5 mm self-tapping screws: bracket mounting
8 Grubscrews: shaft coupling
2 Grubscrews: pushrod connectors
2 Plastic nuts: pushrod connectors
1 M2.5 x 10 mm screw aerial mounting
1 M2.5 nut: aerial mounting
4 2.8 Ø x 7.0 Ø washer: aerial mounting
2 2.8 Ø x 7.0 Ø washers: servo mounting
1 Velcro tape, 25 cm: battery, receiver and speed controller
mounting
1 Decal sheet
The following parts are also required
(not included in the kit)
1 C 3041 servo, Order No. 3899; or a similar servo of the same case size
1 Motor (see table below)
1 Electronic speed controller (see table)
2 Drive batteries, each 4, 6 or 8 cells (see table)
1 Battery link cable, Order No. 3031
1 MX-12 radio control set, Order No. 4723, or other Graupner / JR 40 MHz computer
radio control system
Motor and accessories
Racing class Electric motor
Order No.
Drive battery
Order No.
Speed controller
Order No.
Sport
4 + 8 = 12 cells
SPEED 700 BB
TURBO C 9.6 V
7307
ECO-POWER 8-NiMH 9.6 V / 3.3 Ah
2596.8
ECO-POWER 4-NiMH 4.8 V / 3.3 Ah
2596.4
POWER V60
2847
S-14
6 + 8 = 14 cells
SPEED 700 BB
600 M 12 V
6534
GMVIS GP 8N-3700 NiMH 9.6 V / 3.7 Ah
2491.8
GMVIS GP 6N-3700 NiMH 7.2 V / 3.7 Ah
2491.6
POWER V60
2847
MONO-2
4 + 8 = 12 cells
GRAUPNER INLINE
600 M 12 V
GMVIS GP 8N-3700 NiMH 9.6 V / 3.7 Ah
2491.8
GRAUPNER GENIUS 70
2897
10