Declaration of conformity

HongAn TECHNOLOGY CO., LTD. Report No.: HA110227-CE
CE Test Report Page 9 of 22
1.5 Identifying the Final Test Mode
1. Standby Mode:
2. Operation Mode 1: DC mode.
Note: After pre-test, we identified that the Operation Mode 1(the worst case) was most likely to cause
maximum disturbance and most likely to be susceptible to disturbance. Therefore, the Final EMC
Assessment was performed for the worst case. All pre-test data show at appendix.
1.6 Final Test Mode
Operation Mode 1: DC mode.
1.7 Condition of Power Supply
DC 3 V
1.8 EUT Configuration
1. Setup the EUT as shown in Sec.1.4 Block Diagram.
2. Turn on the power of all equipments.
3. Activate the selected Final Test Mode.
1.9 Qualification of Test Facility
BSMI Certificate No. :
SL2-IS-E-0023, SL2-IN-E-0023, SL2-R1-E-0023, SL2-R2-E-0023,
SL2-A1-E-0023, SL2-L1-E-0023.
FCC Designation No. :
TW1001
Nemko Authorization No. :
ELA 184
TAF Accreditation No. :
1163
VCCI Certificate No. :
R-2156, C-2329, T-219