User's Manual

32 / 48
S1008_X-8E_jh_V1
S/SPEED
Steering and throttle servo speed settings menu.
For the steering servo, you can set the speed for left and right
and for forward and return travel separately.
For the throttle servo, a point can be set at which the speed is
set in two steps.
STEERING
Highlight the field to be adjusted by pressing the appriporiate
button in the LEFT or RIGHT columns and TURN or RETURN
lines. Press the <+ or -> keys to raise or lower value. Press the
curved arrow key to reset to the default value (100).
THROTTLE
HIGH or NEUTRAL: Select the field to be adjusted by pressing
the appriporiate button. Press the <+ or -> keys to raise or
lower value. Press the curved arrow key to reset to the default
value (100).
POINT: To set the switchover point between both ranges, high-
light the button under POINT. Press the <+ or -> keys to raise
or lower value. Press the curved arrow key to reset to the default
value (50).
START
Automatic start function settings menu.
RATE: To allow a quick start without spinning the drive wheels
while the throttle is held on a specific value, press the percent
button below RATE. Press the <+ or -> keys to raise or lower
value. Press the curved arrow key to reset to the default value
(0%).
T/POS: To use this function, first assign a switch that sets the
START function to READY. When the throttle lever exceeds the
set trigger point, the READY (standby) mode is activated. To
adjust the trigger position, press the percent button below T/
POS. Press the <+ or -> keys to raise or lower value. Press the
curved arrow key to reset to the default value (0%).
TIME: To delay the response of this function when exceeding
the trigger point, select the button below TIME. Press the <+ or
-> keys to raise or lower value. Press the curved arrow key to
reset to the default value (0.0s).
BACK
NORMAL
SERVO
LEFT
STEERING
RIGHT
CH
100
TURN
RETURN
100
100 100
BACK
NORMAL
SERVO
HIGH
THROTTLE
CH
100
50
100
NEUTRAL
POINT
BACK
NORMAL
SERVO
RATE
START
0%
OFF
T/POS TIME
0%
0.0s