User's Manual

30 / 48
S1008_X-8E_jh_V1
B-MIX
Break mixer options menu, including mixer channel assignment,
mixer rate setting, delay time and ABS activation.
ACT: To activate the break secure function, press to change
INH (inhibit/off) to ON.
RATE: To set the break mixer part, press the percent button
on the RATE line. Press the <+ or -> keys to raise or lower value.
Press the curved arrow key to reset to the default value (100%).
DELAY: To set a delay time prior to activating the ABS, press
the percent button on the DELAY line. Press the <+ or -> keys
to raise or lower value. Press the curved arrow key to reset to
the default value (0.00s).
ABS: To activate the ABS function, press to change INH
(inhibit/off) to ON.
TH RESP (Throttle Response)
Throttle response settings menu. The throttle and break travel
can be adjusted in one percent incriments, causing the servo to
automatically jump to the set value during operation. This setting
can compensate backlash of the throttle linkage or throttle
response weakness in lower ranges.
FW: 0% - 100% To set the throttle, press the percent button
on the RATE line. Press the <+ or -> keys to raise or lower value.
Press the curved arrow key to reset to the default value (0%).
BK: 0% - 100% To set the break, press the percent button
on the RATE line. Press the <+ or -> keys to raise or lower value.
Press the curved arrow key to reset to the default value (0%).
IDLE UP (Pumping)
Motor start function settings menu. Holds the throttle to a spe-
cific value to enable a better start for cold combustion
engines.
POS: To adjust throttle position, press the percent button on
under POS. Press the <+ or -> keys to raise or lower value.
Press the curved arrow key to reset to the default value (0%).
NOTE: After starting the engine, this function must be deactivated;
the throttle lever has no effect during the IDLE UP function.
CTL: Assign this function to a switch. Refer to the SW SET
chapter for additional information on how to program switches.
BACK
INH
CH 3
NORMAL
SERVO
CH 4
ACT
RATE
DELAY
ABS
INH
+100% +100%
0.00s 0.00s
INH INH
BACK
NORMAL
SERVO
FW
0%
BK
BK
FW
0%
0%
BACK
NORMAL
SERVO
POS
NONE
ACT
SET
CTL
PUMPING
ON
0%
BK FW