User's Manual

28 / 48
S1008_X-8E_jh_V1
TRA ADJ (End Point Adjustment)
End Point Adjustment
This function sets the maximum
travel of the servo per channel.
The left and right deflection can be
set separately in the range from
0% - 150%. Press the related
button. Change the values by
pushing the <+ or -> keys. Press
the curved arrow key to reset to
the default value (100%).
To set the DR (Dual Rate) and EXPO (Exponential) function for
the steering and throttle channel, press the STEERING or
THROTTLE button in the CH line. All setting changes are rep-
resented in the diagram.
Setting STEERING channel
D/R: 0% - 100% Limit the steering course. Press the <+ or ->
keys to raise or lower value. Press the curved arrow key to reset
to the default value (100%).
EXP: -100% to + 100% Exponentially change the steering
course. Press the <+ or -> keys to raise or lower value. Press
the curved arrow key to reset to the default value (0%).
Setting THROTTLE channel
D/R: 0% - 100% Limit the throttle course. Press the <+ or ->
keys to raise or lower value. Press the curved arrow key to reset
to the default value (100%).
EXP: -100% to + 100% Exponentially change the throttle
course. Press the <+ or -> keys to raise or lower value. Press
the curved arrow key to reset to the default value (0%).
FWD: Choose between forward and brake area. Refer to the
D/R and EXP settings described above and the FWD/BRK set-
tings described on the following page.
TYPE: Select between EXPO or throttle CURVE
CURVE: Refer to the setting instructions on the following page.
BACK
100%
LEFT
NORMAL
SERVO
RIGHT
100%
ST
100%
BRK FW
100%
TH
100%
UP DN
100%
CH3
100%
UP DN
100%
CH4
BACK
STEERING
NORMAL
SERVO
CH
100%
D/R
0%EXP
BACK
THROTTLE
NORMAL
SERVO
CH
100%
D/R
0%EXP
FWD
TYPE
EXP
BACK
DR/EXP (Dual Rate/Exponential)